Sony STR-AV1070X - Manual (Page 35)

If the LEARN indicator flashes or does not go out in step
2 - ® . ® .
The memory capacity has become full. This occurs when
other signals stronger than the remote-control signals have
been stored because the signals were programmed In a
noisy environment or the remote commanders were placed
too far apart from each other.
-*• Clear ail the signals following the procedure on the right
and program again from the beginning under the proper
conditions.
Notes on programming
•
Remote-control signals of equipment of manufacturers
other than Sony can be programmed only when they are
compatible with the infrared wireless remote control
system. Since the programmable commander can
learn" only the signals output from another remote
commander, it cannot control equipment that does not
use a remote commander. Also, note that there are
some special remote-control signals that cannot be
programmed.
• Do not attempt to use the programmable commander
with an air conditioner or other household appliances.
To program a new signal onto a previously
programmed button
Follow the programming procedure.
The previously progmmmed signal is cleared and
replaced by the new signal.
To clear all programmed signals
1 Set the mode selector to LEARN.
2 Press and hold any button of the programmable area
until the LEARN indicator lights up.
3 Press PROGRAM CLEAR until the LEARN indicator
flashes and goes off.
Note
It IS not possible to clear the programmed content of just one
button.
To program a signal onto the • REC button in the
TAPE or VTR section
It is not possible to operate any equipment with only the
• REC button. To program a signal under the • REC
button, press and hold the following buttons at the same
time in step 2 - ® .
TAPE
VTR
DECKATR
REC MODE
I REV I L
DECK/VTR
REC MODE
I FWD I
DECK/VTR
REC MODE
I FWD I C
Controlling Equipment
By switching the mode selector as shown below, a single button alternately controls Sony equipment and another
manufacturer equipment.
When Sony equipment cannot be remote-controlled
Program the signal in the same way as for equipment from
other manufacturers. In this case, even with Sony
equipment, set the mode selector to USER STD.
If no signal has been programmed
The programmable commander can control Sony
equipment even when the mode selector is set to USER
STD.
Notes on Battery
If the LEARN indicator does not light when a button is
pressed, the batteries are almost exhausted.
When the batteries are exhausted, the remote commander
can no longer operate the unit or programming becomes
impossible.
If this happens, replace both batteries with new ones. We
recommend the use of alkaline batteries for prolonged use.
If the equipment works incorrectly
Press RESET.
The programmed contents of the buttons are not cleared
by pressing RESET.
35