Editing onto another tape, Before editing, If your vcr is a stereo type – Sony CCD-CR1 User Manual
Page 24: Starting editing, To edit more scenes, To stop editing
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Editing onto another tape
You can save the recorded picture and create your own video program by editing with
any other 0 8 mm, HI0 Hi8, VMS. VHS, SVMS' S-VHS, iVtKH VHSC, SMKH S-VHSC, fD
Betamax VCR or IX’ DV that has video/audio inputs.
Before editing
Connect the camcorder to the VCR using the supplied A/V connecting cable.
Set the input selector on the VCR to LINE, if available.
If your VCR is a stereo type
Connect only the black plug for audio L (left) on the VCR. With this connection, the
sound is monaural even in stereo models
starting editing
Turn off the speaker of the camcorder while editing. Otherwise, picture distortion may
(.Kcur.
(1) Insert a blank tape (or a tape you want to record over) into the VCR.
(2) Play back the recorded video cartridge on the camcorder until you locate the
point just before where you want to start editing, then press
II
to set the
camcorder in playback pause mode.
(3) On the VCR, locate the recording start point and set the VCR in recording
pause mode.
(4) First press
II
on the camcorder, and after a few seconds press
II
on the VCR
when ycHi want to start editing.
To edit more scenes
Repeat stops 2 to 4.
To stop editing
Press ■ on both the camcc^rder and the VCR.
24