Sony CCD-CR1 - Manual (Page 10)

Using house current
When you install or remos'e the battery shaped block of the connecting cord, turn off
the camcorder to prevent misoperation of the camcorder.
(1) To open the lid of the battery compartment, slide the OPEN (ВАТТ) release
lever at the bottom (T the camcorder to the left, then slide it toward you and
release.
(
2
)
Install the battorv shaped block oi the DC connecting cord in the direction of
the arrow. Open the cord cover and pass the cord through. Then close the lid
and slide it until it clicks.
(3) Connect the LXi connecting cord to the AC adaptor/charger.
(4) Connect the power cord to the AC adaptor/charger and a wall outlet.
WARNING
The power eori.1 must bi’ changed only at a qualified service shop.
Note
Ket.’p the .AC .ul.iptor/ch.lrger .u\ a\' from the camcordr'r if the picture is affected.
10"