Sony CDP-CE525 - Manual (Page 28)

Additional Information
Troubleshooting Specifications
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There's no sound.
^Check that the player is connected securely.
^Make sure you operate the amplifier correctly.
^Adjust the output level using the LINE OUT
LEVEL +/- buttons on the remote.
The CD does not play.
^There's no CD inside the player ("-NO DISC-"
appears). Insert a CD.
^Place the CD with the label side up on the disc
tray correctly.
■ ♦ ■ Clean the CD (see page 27).
^Moisture has condensed inside the player.
Remove the disc and leave the player turned on
for about an hour (see page 27).
^Place the CD in the correct position on the disc
tray.
The remote does not function.
^Remove the obstacles in the path of the remote
and the player.
^Point the remote at the remote sensor H on the
player.
■ ► Replace all the batteries in the remote with new
ones if they are weak.
■ ► Set the CD 1 / 2 / 3 switch on the remote
according to the position of the COMMAND
MODE selector at the rear panel of the player.
The player functions incorrectly.
^The microcomputer chips may be operating
incorrectly. Turn the power off, then turn it
back on to reset the pla\'er.
Compact disc player
Laser
Laser output
Frequency response
Signal-to-noise ratio
Dynamic range
Harmonic distortion
Channel separation
Semiconductor laser (/. = 780 nm)
Emission duration: continuous
Max 44.6 pVV*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
2 Hz to 20 kHz ±0.5 dB
More than 107 dB
More than 98 dB
Less than 0.0040%
More than 100 dB
Output
Jack
type Maximum
output
level Load
impedance
LINE OUT Phono
jacks
2 V
(at 50 kilohms) Over 10 kilohms
DIGITAL OUT
(OPTICAL) Optical
output
connector -18 dBm Wa\ e length: 660 nm
PHONES Stereo
phone jack 10 mW 32 ohms
General
Power requirements
Where purchased Power requirements
USA/Canada 120 V AC, 60 Hz
Europe 220 V - 230 V AC, 50 / 60 Hz
Australia 240 V A C , 50/60 Hz
Power consumption
Dimensions (approx.)
(w/h/d)
Mass (approx.)
14 W
430 X 120 X 393 mm
(17 x 4 3 / 4 x l 5 1 / 2 in.) ind. projecting
parts
5.4 kg (11 Ihs 15 oz I
Supplied accessories
Audio cord (2 phono plugs - 2 phono plugs) (1)
Remote commander (remote) (1)
Sonv SUM-3 (NS) batteries (2)
Design and specifications are subject to change without notice.
28