Specifications, Audio power specifications, Amplifier section – Sony STR-V220 User Manual
Page 18: Power output, Frequency response, Inputs, Sensitivity impedance s/n, Weighting network, input level), Fm tuner section, Antenna terminals
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Additional Information
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8 ohm loads, both
channels driven, from 20 -
20,000 Hz; rated 60 watts
per channel minimum RMS
power, with no more than
0.3% total harmonic
distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
stereo mode
(8 ohms 20 Hz - 20 kHz,
THD 0.3%)
60 W + 60 W
Surround mode
(8 ohms at 1 kHz, THD
0.08%)
Front: 60W/ch
Center*: 60 W
Rear*: 60W/ch
* Depending on the
surround mode and the
source, sound will not be
output.
Frequency response
CD, TAPE/MD, TV/SAT,
VIDEO:
10 Hz - 50 kHz ±1 dB
Inputs
Sensitivity Impedance S/N
(weighting
network,
input level)
CD
200 mV
Outputs
TAPE/MD REC OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
VIDEO AUDIO OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
MIX AUDIO OUT:
Voltage: 2 V
Impedance: 10 kilohms
PHONES:
Accepts low and high
impedance headphones
MUTING
Full mute
BASS BOOST
+10 dB at 70 Hz
TONE
±8 dB at 100 Hz and 10 kHz
FM tuner section
Tuning range
87.5 -108.0 MHz
Antenna terminals
300 ohms, balanced
75 ohms, unbalanced
Sensitivity
Mono: 18.3 dBf, 4.5 pV
Stereo: 38.3 dBf, 45 pV
Usable sensitivity
11.2 dBf,2pV (IHF)
S/N
Mono: 76 dB
Stereo: 70 dB
Harmonic distortion at 1 kHz
Mono: 0.3%
Stereo: 0.5%
Separation
45 dB at 1 kHz
Frequency response
30 Hz -15 kHz dB
Selectivity
60 dB at 400 kHz
AM tuner section
Tuning range
With 10 kHz interv'al: 530 -
1710 kHz**
Antenna
Loop antenna
Usable sensitivity
50 dB/m (at 1,000 kHz)
S/N
54 dB (at 50 mV/m)
Harmonic distortion
0.5% (50 mV/m,
400 Hz)
Selectivity
At 10 kHz: 40 dB
** You can change the AM tuning
interval to 9 kHz or to 10 kHz. After
tuning in any AM station, turn off
the receiver. Hold down the
TUNING + button and press the 1/(1)
button. All preset stations will be
erased when you change the
interval. To reset the interval to 10
kHz, repeat the procedure.
General
Power requirements
120 V AC, 60 Hz
Power consumption
130 w
AC outlets
1 switched, 120 W/1 A
maximum
Dimensions
355 x 120 x 325 mm
(14 X 4
^/4
X 12
^/4
inches)
including projecting parts
and controls
Mass (Approx.)
5.7 kg (12 lb 10 oz)
Supplied accessories
See page 4.
Design and specifications are subject to
change without notice.
TAPE/MD,
150
mV
TV/SAT,
VIDEO
82 dB
50 kilohms (A, 150
mV)
18