Sony RM-LJ301 - Manual (Page 15)

Selecting a Sound Field Programming the Remote
Do the procedure below to select a sound field from the
sound field list. Note that the sound fields contained in
each list will vary depending on the receiver.
1 Press SOUND FIELD.
The sound field list appears.
[Music ]
^Stadium
Game_____
Move the easy scroll key to select the sound field,
then press the key to enter the selection.
The display reverts back to the component
information after about ten seconds.
A display example
[Cinema *}-
C.Studio B
^C. Stud io C-
-Genre of the current
sound field
-Current sound field
To turn off the sound field
Move the easy scroll key to select"S.Field OFF/' then press
the key to enter the selection. Or press the S.FIELD ON /
OFF button.
You can customize the remote to match the components
connected to your receiver. You can even program the
remote to control non-Sony components and also Sony
components that the remote is normally unable to control.
The procedure below uses as an example a case in which a
Kenwood LD player is connected to the VIDEO 2 jacks on
the receiver.
Before you begin note that:
—- You cannot change the settings of TUNER and
PHONO.
— The remote can control only components that accept
infrared wireless control signals.
Be sure to turn on the receiver and point the remote
towards the receiver when performing the following
procedure.
1 Press SET UP.
The set up list appears.
I^IR SET
DOWNLOPD
BACK LIGHT
2 Move the easy scroll key to select "IR SEX" then
press the key to enter the selection.
The IR SET list appears.
3
(fi
3
- «
^[ UIDE01 ]
[ UIDED2 ]
Move the easy scroll key to select the component
("VIDEO 2," for example), then press the key to
enter the selection.
The CATEGORY list appears.
Move the easy scroll key to select the category
(i.e., the component that is actually connected to
the corresponding jacks; in this case, "LD"), then
press the key to enter the selection.
The MAKER list appears.
15