Sony RM-V30 - Manual (Page 2)

Using the Remote Commander
Turning On/Off a Component
1
Set the slide switch on the Remote Commander to VCR (to turn
on/off a VCR), CABLE (to turn on/off a cable box), or W (to
turn on/off on a TV).
CABLE
V C R — T V
2
Point the Commander directly at the component.
3
Press the POWER button to power on/off the component.
POWER
o
Operating a Component
1
Make sure the slide switch is set to the component you want to
operate.
2
Point the Commander directly at the component.
3
Press the button for the function you want to use.
See "Remote Button Descriptions" for complete descriptions of the
buttons on the Commander.
Note on Using the Remote Commander
Using this Commander will not increase the functions of your TV,
VCR or Cable box. The functions of the Commander are limited to
the functions of the TV, VCR or Cable box itself.
Remote Button Descriptions
Note:
Buttons marked with * in the following table operate
independently of the position of the slide switch.
Remote Button/
switch Operates Function
CABLE
V C R — T V (M)
TV
VCR
Cable box Used to switch to TV, VCR and
Cable box operation. (Note:
You do not need to use this
switch when using the buttons
with * in this table)
POWER
o
TV
VCR
Cable box Turns on and off the
component.
SET
o
TV
VCR
Cable box
Used for setting up the
Commander to operate your TV,
VCR and cable box.
TV/
VIDEO
o
TV Changes the input mode.
VCR Switches the signals supplied to
the TV (from the antenna or
from the VCR).
CM
0
TV
VCR
Cable box Channel up: +
Channel down: -
VOL
• ©
TV Volume up: +
Volume down: -
*
◄◄
VCR Rewind * ►
VCR Play
* ►► VCR Fast-forward * ■
VCR Stop