Sony RM-V30 User Manual
Setting up the remote commander, Reniote commander
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Reniote
Commander
Operating Instructions
RM-V
30
Sony Corporation © 1994 Printed in Japan
Before operating the unit, please read this manual thoroughly and
retain it for future reference.
Note:
You will need this manual if you plan to use this Commander with
components you may purchase in the future.
Setting Up the Remote
Commander
Before you can start using the Remote Commander, you must first
set it up. This manual describes everything you need to know to
set up the Remote Commander for your TV, VCR and cable box.
About Presetting the Commander
This Remote Commander is preset at the factory to operate Sony
brand TVs and Sony brand VHS VCRs. If you're using this
Commander with a Sony TV and a Sony VHS VCR, you won't need
to preset the Commander before you start using it.
To set up this Remote Commander to use with other (non-Sony)
manufacturer's TVs, VCRs, and cable boxes, you'll need to follow
the instructions in this manual to preset the Remote Commander.
Note
The Commander can be set up to operate only one component of each
category (TV, VCR, cable box) at a time unless their code numbers happen
to be the same. For example, you cannot set up the Commander to operate
a Sony TV and a Panasonic TV at the same time.
Step 1: Searching for the Correct Code
This Commander is preset with the remote control codes of
different manufacturers. Follow the procedure described below to
set the remote control code that operates your TV, VCR or cable
box.
1
Power on the component you want to set up. Then set the slide
switch on the Remote Commander to
VCR
(to set up a VCR),
CABLE
(to set up a cable box), or
TV
(to set up a TV).
CABLE
VCR-»»»-TV
2
Press and release the
SET
button.
SET
o
3
Press aned release the
CH
+ button.
Then press and release the
POWER
button.
POWER
o
4 Repeat step 3 until your component powers off.
Pressing
CH
+ and
POWER
repeatedly will try every available
code until the correct one is found.
Be patient as you do this; it may take up to about 70 tries until
the correct code is located.
5
When the component powers off, press and release the
TV/
VIDEO
button to store this code in the Commander's memory.
TV/
VIDEO
o
To go back to the previous code
If you press
CH
- in step 4, the previous code will be selected.
Step 2: Checking if the Code Works
1
Power on the component you want to set up using the
component's power switch.
2
Aim the Remote Commander at the component and press the
POWER
button.
POWER
o
The component should power off.
3
When the component powers off, check that the Commander is
operating the other functions of your component, such as
channel and volume control.
If the Commander Does Not Seem to Be Working
Properly ...
■ Try repeating these setup procedures until another code
operates your component properly.
■ If you still cannot get the Commander to work properly, see
"Troubleshooting".
If the Commander Seems to Be Working Properly ...
■ You're finished setting up the Commander for this component.
■ If you're setting up more than one component, you'll need to
complete these procedures for each component you plan to use
with the Commander.