Sony SA-VA500 - Manual (Page 9)

Getting Started
Turning the Speaker System On
and Off
1—;---------------r
| gd CD
CD SD CED
GD CD CD
io ©
O
i ©
©
0
©
0
c~> ® cs
joD GD GD
iC3 GD GD
T.TONE
INPUT
SELECT
]/(!)
DIMMER
Turning on the speaker system
Press © on the lower part of the left front speaker.
The ON indicator on the left front speaker lights up.
When the speaker system is in standby or ready mode
(i.e., the STANDBY or READY indicator on the left
front speaker lights up), press INPUT (or either I/© or
INPUT SELECT on the remote).
Turning off the speaker system
When you press ®, the ON indicator goes off and the
speaker system is totally deactivated.
When you press
I/© on the remote, the speaker system
enters standby mode (the STANDBY indicator on the
left front speaker lights up).
Power turns on and off automatically
(Auto power on/off function)
When you turn off the TV, the speaker system
automatically turns off three minutes afterwards (the
READY indicator lights up).
The speaker system turns on again when you turn on
the TV. The speaker system also turns on when you
press INPUT (or either
I/© or INPUT SELECT on the
remote).
This function operates only when TV input is selected
("TV" appears in the display).
If you press I/© on the remote while the system is
on
The speaker system enters standby (the STANDBY
indicator lights up). Press I/© on the remote to turn the
speaker system on again.
Adjusting the contrast of the display
window
You can dim the display or turn it off.
Press DIMMER on the remote repieatedly until your
favorite brightness of the display comes up.
The displav returns to full brightness temporarily
when you press one of the buttons on the remote.
Checking the speaker connections
1 Turn on the speaker system.
The ON indicator lights up.
2 Press INPUT (or INPUT SELECT on the remote)
repeatedly until "5.1 CH IN" appears in the
display.
3 Adjust the volume level to around 15 with
MASTER VOL +/-.
4 Press T.TONE on the remote.
Check that the test tone is output from each speaker
in following order:
I > Front (Left) Center Front (Right) “l
I Rear (Left) ^ Rear (Right) < I
5 Press T.TONE on the remote to turn the test
tone off.
'Q' If the test tone is not output in the order
indicated in step 4
Turn off all components, then check the connection
of the speaker that did not output the test tone.