Sony MZ-R55 - Manual (Page 34)

Messages
If the following error messages flash in the display window, check the chart below.
Error message Meaning/Remedy
BLANK DISC • An MD with no recording on it is inserted.
♦ Insert a recorded MD.
DISC ERR • The disc is damaged or does not contain proper recording or
editing data.
♦ Reinsert the disc. If this fails, rerecord.
DISC FULL • There is no more space to record on the disc (less than 12 seconds
available).
•¥■ Replace the disc.
Data Save • The MD player is recording information (sounds) from the memory
to the disk.
^ Wait until this process is completed. Do not expose the player
to any physical shock, nor disrupt power supply.
Toe Edit • The MD player is recording information (track start and end
position) from the memory to the disk.
^ Wait until this process is completed. Do not expose the player
to physical shock, nor disrupt power supply.
BUSY • You tried to operate the recorder while it was accessing the
recorded data.
Wait until the message goes out (in rare cases, it may take 2-3
minutes).
NAME FULL • You tried to enter more than 200 letters to label a single track or
disc.
• You tried to enter a total of more than 1700 letters for track or disc
names during playback or stop.
• You tried to enter a total of more than 500 letters for track or disc
names during a single recording.
♦ Enter the characters within the limit.
Hi DC in • Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
Use the supplied AC power adaptor or the recommended car
battery cord.
HOLD • The recorder is locked.
4- Slide HOLD against the arrow to unlock the recorder (page 20).
LOW ВАТТ • Batteries are weak.
^ Charge the rechargeable battery or replace the dry batteries
(pages 27, 28).
MEM OVER • You tried to record when there is no indication in the display, with
the recorder placed where it receives continuous vibration.
4- Put the recorder on a stable place, and start recording again.
34