Sony MZ-R55 - Manual (Page 32)

Symptom Cause/Solution
No sound comes
through the
headphones.
• The headphones plug is not firmly connected.
^ Plug in the plug of the headphones firmly to the remote
control. Plug in the plug of the remote control firmly to
0/REMOTE.
• Volume is too low.
^ Adjust the volume by pressing VOLUME +/- (VOL +/- on
the remote control).
• AVLS is on.
Slide AVLS to NORM (page 18).
An MD is not played
from the first track. • Disc playing stopped before it came to the last track.
Press K4 repeatedly or open and close the lid once to go
back to the beginning of the disc, and restart playing after
checking the track number in the display.
Playback sound skips. • The recorder is placed where it receives continuous vibration.
Put the recorder on a stable place.
• A very short track may cause sound to skip.
Sound has a lot of
static. • Strong magnetism from a television or such device is interfering
with operation.
Move the recorder away from the source of strong
magnetism.
Cannot find the track
marks. • You pressed II after pressing or ►►!.
^ Press II before pressing or ►►!.
The rechargeable
battery does not start
charging.
• The rechargeable battery has been inserted incorrectly or the AC
power adaptor has been connected incorrectly.
Insert the battery correctly or connect the AC power adaptor
correctly.
The clock loses time
or the display flashes.
The recording date
was not stamped onto
the. disc. • The built-in battery for the clock is weak.
Connect the AC power adaptor to DC IN 3 V on the recorder
and the wall outlet to charge the built-in battery. After
charging, set the clock again (page 16). Note that the clock
may gain or lose up to about 2 minutes per month under
normal condition.
The lid does not
open.
• The power sources have been disconnected during recording or
editing, or the batteries have been exhausted.
♦ Set the power source.s again, or replace the exhausted
batteries with new ones.
32