To change scanning direction, To resume scanning manuaily during scanning pause, Programmable scanning – Sony ICF-SC1 User Manual
Page 8: Defining the frequency range, Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

• When thi' e'lirrent t.irget
ocaipiod ch.inni'l (i.o., tho
h.i“' no channel with a prc5:et trequenev), the Jispla\- will be
as toilou s.
In this ease, first add a \’alid target page if this is the onl\- targ
page, then, discard this page from the target page.
•It all the preset channels in a current target page are SKll’-
designated frequencies, the display will be as follows.
Ql/T”
PAGE
- O -
^ 1 ^
IJI 1
1IL L
SKIP
In this case, first add a valid page to the scanning target page if
this is the only target page, then, discard this page.
To
change
scanning direction
Press + or - .
To resume scanning manuaily during scanning
pause
Press + or - .
Programmable Scanning
Programmable Scanning scans a trequenev range vou
have detined step bv step. You can also specifv the
frequency step and the detection iiuxie.
Defining the frequency range
Define the range bv specifying the lower and the upper
limits of the range. The preset channels for the upper and
lower limits are located after channel 30 of page 10. You
cannot use anv other channel for this purpose.
1
Set the SQL control to MIN.
2
Press POWER to turn the receir er on.
3
Tune in, by any way, to a frequency to be specified as
the lower limit of the range.
4
Adjust the frequency step and the detection mode.
Press STEP repeatedly to select a frequency step of
your choice.
Press MODE repeatedly to select a detection mode of
your choice (see "Adjusting frequency step and
detection mode", page 31).
Skip this step to select the default step and detection
mode.
5
While holding down ENTER, press "10/0", then EXE.
"PRESET" and the preset number will flash in the
display. (Do not release ENTER).
6
While holding down ENTER, press + or - repeatedly
until "PRESET L" appears for the preset number
display.
With each press, the preset number display will
change as follows.
W-
E'3
jn.
JU
L LI
^
"L" ("Lower limit") comes after preset channel 30.
(Do not release ENTER).
7
While holding down ENTER, press EXE again.
The lower limit frequency has been memorized in
preset L,
8
Repeat steps 3 to 7 to memorize the upper limit
frequency in preset U. "U" ("Upper limit") comes
after preset L.
Select the same frequency step and detection mode as
you did for the lower limit frequency.
Notes
•You can specify either frequency first
•If you have selected a different frequency step or detection mode
for the upper and lower limits, the tine(s) memorized later will
take precedence.
•The delay setting is not saved for preset channel L or L.
1 4
1 5