Sony ICF-SC1 - Manual (Page 17)

^Additional information
Key protection Troubleshooting
I’rt'ss LICHT/O-n tor I second or loili^cr. "O-n" will li^lu
ill the dispUiv and all keystrokes will be neutralized.
Use this feature to avoid operation bv inadvertent
keystrokes.
To cancel key protection
Press LlGHT/o-n again for 1 second or longer.
Turning on the light
Tress LICHT/o-n lightlv (less than 1 second).
The light in the display window will light tor about 10
seconds.
It you press any operation button while the light is on, the
light will be lit for another 10 seconds.
To turn off the light
Press LIGHT/o-rt again.
Notes
•The light is lit continuously when the receiver is run on external
power (i.e., AC power adaptor or the car battery cord).
To turn off the light, press LIGHT/o-". Press again to turn the
light on again.
•Pressing LIGHT/o-n will not light the window while the power
is turned off.
Turning off the beep
You can turn th'e beep'sound off.
1
If the power is on, press POWER to turn off power.
2
Press POWER while holding down EXE.
"bP off" will be displayed before the power turns on.
L O - C C
IJI Lll I
To turn on the beep again
Repeat the above.
”bP on” will be displayed before the power turns on.
L O
_ _
Lll IJI I
Should anv problem persist atter these tests, consult vour
nearest Sonv dealer.
The power does not turn on.
• The batteries are exhausted.
—► Replace all batteries with new ones.
• The batteries are inserted with incorrect polarity, or the
AC power cord or the car battery cord is not connected
properly.
—► Power the receiver correctly.
• Key protection is active (o-n is present in the displavU
—► Release kev protection.
There is no sound.
• The batteries are exhausted.
—► Replace all batteries with new ones.
• The batteries are inserted with incorrect polarity, or the
AC power cord or the car battery cord is not connected
properly.
—► Poiver the receiver correctly.
• The VOL control is turned down completely.
—► Adjust it to a moderate level.
• The SQL control is turned up too far clockwise
(towards MAX).
—* Adjust it properly (page 11).
• The earphone is plugged in.
Cannot operate.
• Key protection is on.
—► Turn off key protection.
Reception is weak or unsatisfactory.
• Weak batteries.
• The station is not tuned in correctly.
• The antenna is not attached properly.
• You are listening under inferior conditions. In a car or a
building, try listening near a window.
• The detection mode does not match the band.
—► Select the detection mode that matches the band
(page 31).
Scanning does not begin.
• The SQL control is turned down too far
counterclockwise (towards MIN).
—> Adjust it properly (page 11).
• The reception is strong.
—► Resume scanning manually.
• You are in Memory Scanning and have only one station
preset in the memory.
Scanning does not stop.
• Reception is rveak (see "Reception is weak or
unsatisfactory", above).
• SQL control is turned up too far clockwise (towards
MAX).
—► Adjust it properly (page 11).
32 33