Priority scanning, Specifying the priority frequency, Running priority scanning – Sony ICF-SC1 User Manual
Page 14: To cancel priority scanning, Notes, Running programmable scanning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Priority Scanning
Priority Scanning
Spociiv a pric>rit\' frequoncN ot vour choice to the priority
channel. With IVioritv Scanning, the receiver checks the
prioritN^ channel everv 5 seconds and switches to this
channel it there is reception. It reception is broken, the
recei\ er
wiW return to previous status.
You can run Priority Scanning during anv scanning or
tuning modes.
Specifying the priority frequency
Tho priority channel is preset channel 30 on page 10. 3 ou
cannot use any other channel for this purpose.
1
Set the SQL control to MIN.
2
Press POWER to turn the receiver on.
3
Tune in, by any way, to a frequency you wish to
specify as the priority frequency.
4
Select the detection mode and the DELAY setting of
your choice.
Press MODE repeatedly to select a detection mode of
your choice (see "Adjusting frequency step and
detection mode", page 31).
Press PRI/DELAY for 1 second or longer to select the
DELAY setting of your choice (see "Adjusting
scanning pause time", page 30).
Skip this step to select the default detection mode and
DELAY setting.
5
Preset the frequency to preset channel 30 ("Priority
channel") on page 10 (see "Presetting stations in the
memory", page 22).
PAGE
ч'М 1 1 |1(P/
ШШ
--
PRESET
Zin
"
DELAY
5k
''
1 1 1 Г 1 1 ''
NFM
IC ri nrin
1
JLI.LIULI
MHz
• All tuning kc\' operation becomes metti'ctn e when recei\'ing the
prioritx channel with I’ricnitY' Scanning teveept tor that using 4
lode
Ml
!’riont\'
ir I o
Itch
to other scanning or tuning
Scanning hrst b\' pressiui; ГR|/Old..•\^ .
•Though the lrei.|uenc\ step >etting is memori/ed tt>r liie pnoritx'
channel, it has no ettect on I‘’noritv Scanning.
• It \'ou tr\ to run PrioritN’ Scanning leith no priority trequenev
(i.e., there is no frequenev preset tor the priority channel, preset
channel 3t^ on page 10), the tollowing will be displav ed
momentarib’, and then tlie receu’er will return to pre\’ious status
PAGE
10
PRESET in
JLI P
•It you try to run IViority Scanning with the priority frequency
designated as a SKIP frequency, the following \\-ill be displayed
momentarily, and then the recei\'er will return to pre\'ious status
PAGE
10
PRESET in
Du P
\l I n,
NFM l>Z J П1 II I
;
SKIP :
IJL.LIIJLI
'мне
•You cannot assign the priority frequency to any other channel
than channel 30 on page 10.
Running Priority Scanning
1
Press PRI/DELAY lightly (i.e., less than a second).
"PRl" will appear in the display and the Priority
Scanning is in effect.
The receiver will check the priority channel every 5
seconds and switches to this channel if there is
reception.
2
Adjust the SQL control (see page 11).
To cancel Priority Scanning
Press PRI/DELAY lightly (i.e., less than a second) again.
Notes
•You can run Priority Scanning during any scanning or tuning
modes
26
27