Sony ICF-SC1 - Manual (Page 15)

►other useful functions
SKIP function
You oin designate anv trequenev as a SKIP-frequone\- (up
to 100). The receiver will skip this frequency during
scanning. Designate any unwanted frequency
(interference signals, etc.) as a SKIP-frequency.
Designating a SKIP-frequency
1
If you are in the Scanning Mode, press SCAN to enter
the Manual Mode.
will disappear from the display.
2
Tune in, by any way, to a frequency you wish to
specify as a SKIP-frequency.
3
Press SKIP.
The frequency is designated as a SKIP-frequency.
To erase all SKIP memory at once
Press EXE, -, and SKIP siniultaneousK .
"dEL ALL SKIP" will flash in the displai.
y I M II I M
- JC> Ql >
- LIL L IIL L
11 M-t 1 1-f-
I I i I /
S K I P -
-t-i-t-
Hold the buttons down for 3 seconds or longer.
The flashing will stop and all the SKIP memory is erased.
The receiver will automatically enter the Band Scanning
mode in the lowest band.
page 1
DELAY
5k
~ic nnn SKIP
AM L J.LIUU MHz
To cancel SKIP designation
Press SKIP again.
SKIP-frequenev designation is effective for any of the Scanning
Modes.
To display the SKtP-frequencies
Press +/- while holdifig down SKIP.
The SKIP-frequencies will be displayed one by one in
ascending/descending order.
When there is no SKIP-frequency, the following display will
appear momentarily, and then the receiver will return to the
previous status.
SKIP
1 lU
Note
You can designate up to 100 SKIP frequencies. If you try to
designate a SKIP-frequency when there is alreadv 100, the
following display will appear momentarily, and then the receiver
will return to the previous status.
C I i
t ULL
SKIP
In this case, cancel a previouslv designated SKiP-frequenev first.
28
29