Sony PCG-735 - Manual (Page 3)

I Use caution when installing or
modifying telephone lines.
I Avoid using-the modem during an
electrical storm.
I Do not use the modem or a telephone
to report a gas leak in the vicinity of
the leak.
I A socket outlet should be as ckise as
possible to the unit and easily
accessible.
! The use Of optical instruments
«v^ this product will increase eye
hazard.
AVERITISSEMENT
Pour prévenir tout risque d'incendie
ou d'électrocution, garder cet appareil
à l'abri de la pluie et de l'humidité.
Pour prévenir tout risque
d'électrocution, ite pas ouvir le châssis
de oet appareil et ne confier son
entretien qu'à une personne qualifiée.
L'appariel doit être le plus près
possible d'une prise murale pour en
faciliter l'accès.
Regulatory Information
Dectaration of Conformity
Trade Name: SONY
Model No; PCG-731 /PCG-735
Responsible Party:
Sony Electronics Inc.
Address:
1 Sony Drive
Park Ridge, NJ 07(Sf,
Telephone No.: 201-93(W970
This device com plies with Part 15 of
the FCC rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interfererKC, and (2) this device
must aocept any interference that
may cause undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user
is encouraged to try to correct the
interference by one or more of the
following measures:
□ Reorient or relocate the receiving
' antetma.
□ Increase the separation between the
equipment and the receiver.