Sony CDP-XA7ES - Manual (Page 9)

-4<
Getting Started
I
What cords will I need?
■ When making analog hookups
• Audio cord (supplied) (1)
White
(L)
Red
(R)
White
(L)
Red
(R)
■When making digital hookups
• Optical cable POC-15 (not supplied)
-cQ>
• Coaxial cable (not supplied) (CDP-XA5ES only)
Hookups
■When making analog hookups
When connecting an audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player Amplifier
LINE OUT ' INPUT '
FIXED CD
-©L
“0R R©-©^
l|
If you have an analog power amplifier
Connect the amplifier via the VARIABLE LINE OUT jacks
using the supplied audio cord. You can adjust the output
level with the LINE OUT/PHONE LEVEL control on the
player or the LINE OUT LEVEL buttons on the remote.
CD player Amplifier
LINE OUT ' INPUT '
VARIABLE o©^
lo©^
CD
—0L
-©R
■When making digital hookups
Note that you cannot use fading in or out (page 16)
and time fade (page 17) functions when making this
connection.
If you have a digital component with an optical digital
input connector
Connect the component via the DIGITAL OUT (OPTICAL)
connector using the optical cable (not supplied). Take off
the cap and plug in the optical cable.
CD player Digital component
If you have a digital component with a coaxial digital
input connector (CDP-)(A5ES only)
Connect the component via the DIGITAL OUT (COAXIAL)
connector using the coaxial cable (not supplied).
CD player Digital component
Note
When you connect via the DIGITAL OUT connector, noise
may occur when you play CD software other than music, such
as a CD-ROM.
Setting the voltage selector (only for
CDP-XA3ES with the voltage selector)
Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to a wall outlet.
110- 120 V 220 - 240 V
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Removing the notice sheet (CDP-XA5ES only)
The notice sheet is put on the player. Remove the sheet
before you use your player.
Where do I go next?
Now you're ready to use your player.
If you aren't fam iliar with how to play CDs, go to the section
"Playing a CD" on page 4.
Then, go to the following sections for other operations.