Digital component, Note, Connecting the ac power cord – Sony CDP-XA7ES User Manual
Page 8: Removing the notice sheet, Overview, I—: signal flow, Digital out optical line out variable, Hooking up the system (for cdp-xa5es/xa3es), Getting started, Where do i go next
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
8
Getting Started
If you have a digital component with a coaxial digital
input connector
Connect the component via the DIGITAL OUT (COAXIAL)
connector using the coaxial cable (not supplied).
CO player
Digital component
COAXIAL
DIGITAL INPUT
COAXIAL
After making connections, press DIGITAL OUTPUT
on the player to turn on the DIGITAL OUT indicator.
Note
When you connect via the DIGITAL OUT connector, noise
may occur when you play CD software other than music, such
as a CD-ROM.
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Removing the notice sheet
The notice sheet is put on the player. Remove the sheet
before you use your player.
Where do I go next?
Now you're ready to use your player.
If you aren't fam iliar with how to play CDs, go to the section
"Playing a CD" on page 4.
Then, go to the following sections for other operations.
Hooking Up the System
(for CDP-XA5ES/XA3ES)
Overview
This section describes how to hook up the c,D player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
■ For CDP-XA5ES
LINE OUT DIGITAL OUT DIGITAL OUT
VARIABLE OPTICAL COAXIAL
CDP-XA5ES
To an AC outlet
I—: Signal flow
■ For CDP-XA3ES
DIGITAL OUT OPTICAL LINE OUT VARIABLE
CDP-XA3ES
I
Signal flow
To an AC outlet