Two Brothers Racing Suzuki Gladius - Manual (Page 5)

ITBR001-262 2009-10 Suzuki Gladius - 5
Figur
e
G
Figur
e
H
unplug
13 Locate the stock O2 sensor connection.
The O2 sensor connection is located under the fuel tank as shown in Figure G.
14 Unplug this connection.
The stock O2 sensor will not be connected to anything at this time. It can be
removed from the exhaust if you have a way to cap the bung.
15 To disable the F1 light when the O2 sensor is unplugged, remove the black/brown
wire of the ECU. This is pin #23 from the black connector.
Remove the orange retainer and then use a pick or very small screwdriver to release
the tab inside the connector while pulling on the wire from the back side.
16 Reinstall the air box if it was removed.
17 Reinstall the fuel tank.
18 Reinstall the passenger seat and main seat.