Two Brothers Racing Kawasaki Z1000 - CA Emissions Legal - Manual

Two Brothers Racing
Juice Box™ - Fuel Controller
2007-08 Kawasaki Z1000 Installation & Operation Manual
Part # 008-177C
Parts Incuded
Installation Instructions
Qty. Description Part Number
1 Juice Box™ Fuel Control Kit 008-177C (#9140085C)
3 Zip Ties
1 Adhesive Velcro Square
V.A.L.E.
V a r i a b l e a x i s l o c k i n g e x h a u s t
TM
Remove rear tank mount bolt and gently slide tank toward
the rear of the bike. Prop the tank up exposing the fuel
injector connectors. (Fig 5)
Route the JUICE BOX™ harness from the storage
compartment under the front seat to the fuel injector
connectors. (Fig 6)
Attach the adhesive backed hook and loop material to
the back of the JUICE BOX™ and side of the storage
compartment under the front seat. (Fig 7)
Disconnect the injector connectors from the injectors.
Connect the JUICE BOX™ female and male connectors
to the injectors and the injector connectors that were just
disconnected. (Fig 8)
6.
7.
8.
9.
IMPORTANT - PLEASE READ CAREFULLY
Warranty
two brothers racing warrants that this product carries a warranty for 2 years from date of purchase against original
defects in materials and workmanship. should this product fail to perform for either of the above reasons, two brothers
racing will repair or replace it with an equivalent product at no charge, except for postage, to the original retail purchaser.
to obtain the benefits of this warranty, the retail purchaser must return the product and proof of purchase to the place of
original purchase.
We recommend that this performance part be installed by a qualified motorcycle
technician. If you have any doubts as to your ability to install this performance part,
please consult with your local motorcycle dealer. Read all instructions first before
starting installation. Make sure the vehicle and exhaust system are completely cool
before starting the installation. Also, make sure the vehicle is secure during installation.
Be sure to save all stock components for possible use later.
This Juice Box is legal for use on Emissions Controlled street and highway vehicles.
The Juice Box™ is not applicable, nor inteded for use on aircraft.
Thank you for purchasing a genuine Two Brothers Racing
JUICE BOX™. This product represents a radical step
forward in tuning fuel-injected motorcycles and ATVs for
optimal performance using “load-based” technology.
We at Two Brothers Racing hope that you will find this
development as exciting and useful as we do. And
remember: Proper Fuel = Maximum Power!
Make sure the vehicle is completely cool before starting
the installation. Also, make sure the vehicle is secure and
will not roll around.
Remove the rear seat using the key lock under the left
side of the rear seat. (Fig 1)
Remove the front seat by pulling the loop and lifting the
front seat. (Fig 2)
Remove the bolt that secures the small right side tank
cover and gently pop the cover off. Repeat for left side.
(Fig 3)
Remove the bolt that secures the large right side tank
cover and gently pop the cover off. Repeat for left side.
(Fig 4)
1.
2.
3.
4.
5.
Continued on page 2
Fig 1
Fig 5
Fig 2
Fig 3
Fig 4
Fig 6
Fig 7
Fig 8