11 a, 11 b, 11 d 11 c – Samson DOUBLE BRAID Class II Eye Splice Modified for Turbo-37 User Manual
Page 5
PAGE 5 OF 5
SamsonRope.com
| Tel
+1.360.384.4669
Double Braid Class II Eye Splice Modified for Turbo-37
S A M S O N S P L I C I N G I N S T R U C T I O N S
One at a time, pull the 2 strand bundles
through the throat of the eye. Pull the bundles
tight and tape them down on the back side of
the rope. Turn the rope over and repeat with the
remaining 2 bundles.
tape
11
A
2 x rope diameter (minimum)
Seize over the area (from the throat of the eye
down the standing part) for a distance of
2 times rope diameter (in inches) using nylon
seizing material.
11
B
2 x rope diameter (minimum)
Milk all of the excess cover slack from the
cover material down towards the standing
part of line. Tightly tape the cover to the
rope approximately equal to rope diameter
(in inches) back from the end of the cover.
Unbraid the cover strands from the tape to
the end.
Seize over the area for a distance of 2 times rope diameter (in inches) with nylon seizing material.
After seizing both ends of the cover material, apply a two-part urethane coating over the seized areas as
shown, extending the urethane coating 1/2 the length of the seized area on both sides of the seizing.
Seized area
Coated area
Seized area
Coated area
11
D
11
C
DOCUMENT Double_Braid_C2_Eye_Splice_Turbo 37.pdf
© 2012 Samson Rope Technologies, Inc. All rights reserved.
S/WD #108294 7/2012