Samson DOUBLE BRAID Class II Eye Splice Modified for Turbo-37 User Manual
Page 2
PAGE 2 OF 5
SamsonRope.com
| Tel
+1.360.384.4669
Double Braid Class II Eye Splice Modified for Turbo-37
S A M S O N S P L I C I N G I N S T R U C T I O N S
s p l i c i n g c e n t e r c o r e
s p l i c i n g t o p 3 c o r e s
5
step
The first part of the splice uses the center core and the center
core tail (core #1). Both the center core and the tail should be
pulled out between the top 3 cores and the bottom 3 cores. Put
the center core tail under the center core so that the 2 sections
continue in the line of the 2 legs of the splice. Begin tucking the
core tail into the standing part where they intersect.
Lay out the top 3 cores and core tails as shown above.
Maintain the angle of the legs of the eye splice when positioning
the cores and core tails. Pass core tail #4 under cores #4 and #3
and then begin tucking into core #2 where they intersect.
Pass core tail #3 over core #4 and begin tucking into core #3.
Finally, begin tucking core tail #2 into core #4.
When finished, the rope should appear as shown in Fig. G.
6
step
3 bottom core tails
Top 3 cores
3 bottom core
tails
The cores are arranged
parallel within the
braided jacket
with one core
in the center
and six cores
around it.
The cores
are numbered
in the splicing
instructions to help
identify which core is
used when splicing.
1
2
3
4
5
6
7
Center core tail
6 core tails
6 outer cores
Center core tail
Center core #1
Center line
of eye
Center line
of eye
Standing side
4
3
2
4
3
2
Figure g
Tail side