Samson DOUBLE BRAID Class II Eye Splice Modified for Turbo-37 User Manual
Page 4
PAGE 4 OF 5
SamsonRope.com
| Tel
+1.360.384.4669
Double Braid Class II Eye Splice Modified for Turbo-37
S A M S O N S P L I C I N G I N S T R U C T I O N S
t u c k i n g e y e c o v e r B u n d l e s
Next, tuck the 6 cover braid yarn bundles at the base of the eye. With the eye laying flat (as shown in Fig. I) take bundle closest to the
throat of the eye (bundle #1) and pass it under core A. Take the next cover yarn bundle (#2) and pass it under core B. Take core bundle
#3 and pass it under core C.
10
step
To be tucked on other
side of rope
6
5
4
3
2
1
A
B
C
Cut ends off at angle
3 sets of tucks minimum
Tape exposed splice for the entire length
Turn rope
over
Figure i
Figure J
Turn the rope over and continue this process with the 3 remaining cover yarn bundles (Fig. J). The direction of the tucks should be
as shown. Tape around the rope at the point where the tucks occur. Repeat this procedure until a minimum of 3 tucks have been
completed. When the last set of tucks has been made and taped, cut off excess cover yarn bundles flush with the last taped section.
11
step
Slide the cover material (which was put on the rope in Step 3) up over the exposed
cores. At the eye-end of the splice, separate the strands of the cover material into 4
equal size bundles (2 on the top of the rope and 2 on the bottom.)
Top of rope
2 legs
of the eye
Slide cover material over
exposed cores
tape
F i n i s h i n g t h e s p l i c e