Casio Stylus User Manual
Page 37
37
1
Power Supply
Charging the Battery with the AC Adaptor
Pull back the rubber cover from the AC adaptor jack and insert the cable. The
battery pack takes about 5 hours (when the Rugged PDA is turned off) to fully
charge, and then the left side indicator LED lights green. Under the same condi-
tions, the built in backup battery takes four hours to fully charge.
Remove the AC adaptor cable in the following order q ➔ w ➔ e.
If the left side indicator LED goes out during charging, then the internal protection
circuit may have terminated charging. If this happens, remove the AC adaptor and
the battery pack from the Rugged PDA and then reattach them again and then
start charging again. If this happens frequently it may indicate a malfunction,
contact your original dealer or authorized CASIO distributor.
• You can use the Rugged PDA while it is charging. However, the time
to charge the Rugged PDA may vary greatly depending on the opera-
tions performed on the Rugged PDA (and the surrounding tempera-
ture or other factors).
• Charging requires a longer than normal time when doing initial setup
after purchase or when charging a newly purchased battery pack for
the first time.
q
e
w
Warning!
Use the AC adaptor specified by CASIO. Using the AC
adaptor that is not specified may cause a fire.
N o t e
When the battery pack is fully
charged, remove the AC adaptor
cable and be sure to replace the
rubber cover to its original position.
IT-10_1/25-39-E.p65
06.6.15, 6:40 PM
37