Craftsman CRT/A - Manual (Page 19)

-18-
Router Table for the Craftsman
OPTIONAL ACCESSORIES
R. Dust Extraction Equipment
The Back Fence is provided with an extraction point for
fitting to suitable dust extractors. The internal hole
diameter is 57mm (2 1/4"). Suitable fittings with 57mm
outside diameter are available with most extractor units.
Only a dust extractor unit recommended for use in the
workshop should be used.
A suitable adaptor and extraction hose can be purchased
as optional accessories as follows:
Extraction Hose - 39mm OD - 3 metre length.........CRT/
4
Hose Adaptor - 58mm OD to 39mm ID..................CRT/3
The hose has an outside diameter of 39mm and inside
diameter of 32mm and is designed to fit the hose adap-
tor. The hose adaptor is a unique design allowing it to
swivel freely when fitted to the hose.
Assembly of Hose Adaptor
1. Slide Adaptor Clip onto end of the Extraction
Hose CRT/4 with tabs facing outwards.
2. Screw the Adaptor Fitting anti-clockwise onto
hose, ensuring that the Extraction Hose is
screwed in all the way.
3. Fit the Adaptor Tube by locating the holes with the
tabs of the Adaptor Clip.
4. Push the assembly into the back fence connection
point with a slight twisting action to ensure a tight
fit.
5. Fit the other end of the extraction hose to your dust
extractor.
Extraction Hose - CRT/4
Hose Adaptor - CRT/3
fig. R
Hose Adaptor
CRT/3
Adaptor Clip
Extraction
Hose
CRT/4
Adaptor Tube
Adaptor Fitting
Back Fence
39mm
57mm
Extraction Point
Tabs