beautypg.com

Eliminating resource conflicts, Eliminating resource conflicts -5, Olplqdwlqj5hvrxufh&rqiolfwv – Dell OptiPlex E1 User Manual

Page 35

background image

Basic Troubleshooting

2-5

9HULI\ WKDW DOO FKLSV ',00V DQG H[SDQVLRQ FDUGV DUH IXOO\ VHDWHG

LQ WKHLU VRFNHWV RU FRQQHFWRUV

:$51,1*6 7KH VLQJOHHGJH SURFHVVRU SDFNDJH 6(33

FDUWULGJHKHDW VLQN DVVHPEO\ FDQ JHW H[WUHPHO\ KRW %H VXUH WKDW

WKH DVVHPEO\ KDV KDG VXIILFLHQW WLPH WR FRRO EHIRUH \RX WRXFK LW

:KLOH UHVHDWLQJ WKH 6(33 FDUWULGJHKHDW VLQN DVVHPEO\ XVH D

ZULVW JURXQGLQJ VWUDS RU PDLQWDLQ FRQWDFW ZLWK D PHWDO VXUIDFH RQ

WKH FKDVVLV

The microprocessor is physically located in a SEPP cartridge/heat sink
assembly on the system board. To reseat the microprocessor, remove the
SEPP cartridge/heat sink assembly and reinstall it as described in “SEPP
Cartridge/Heat Sink Assembly” in Chapter 4.

To reseat a DIMM, remove it from its socket and reinstall it as described in
“DIMMs” in Chapter 4.

If you need to reseat an expansion card, remove it from its connector and
reinstall it as described in “Expansion Cards” in Chapter 4.

9HULI\ WKDW DOO MXPSHUV DUH VHW FRUUHFWO\

For information about these jumpers, see “System Board Jumpers” in
Chapter 1.

&KHFN DOO FDEOH FRQQHFWRUV LQVLGH WKH FRPSXWHU WR YHULI\ WKDW WKH\

DUH ILUPO\ DWWDFKHG WR WKHLU DSSURSULDWH FRQQHFWRUV

5HLQVWDOO WKH FRPSXWHU FRYHU

5HFRQQHFW WKH FRPSXWHU DQG DQ\ DWWDFKHG SHULSKHUDOV WR WKHLU

SRZHU VRXUFHV DQG WXUQ WKHP RQ

Does the problem appear to be resolved?

Yes. No further steps are necessary. Terminate the procedure.

No. Proceed to the next sections, “Eliminating Resource Conflicts,” “Run-
ning the System Diagnostics,” and “Getting Help.”

(OLPLQDWLQJ5HVRXUFH&RQIOLFWV

Devices within the computer may require dedicated memory spaces, interrupt
levels, or DMA channels, all of which must be allocated during installation of
the devices. Because a device may be installed at a different time, it is possible
that the same resource is assigned to two or more devices.

Resource conflicts can result in disorderly or erratic system operation or failure
of the system to operate at all. If you suspect that resource conflicts might
exist, check the system and reassign the resources as necessary.