Dell OptiPlex E1 - Manual (Page 22)

1-14 Dell OptiPlex E1 Managed PC Service Manual
3LQ$VVLJQPHQWVIRUWKH'&3RZHU&RQQHFWRUV
The power-supply output voltages can be measured at the back (wire side) of
the connectors without disconnecting them. Figures 1-8 through 1-10 show
the wire side of the connectors.
1
Pin 11 — PSON# should measure between +4 and +5 VDC except when the power button
on the front panel is pressed, taking PSON# to its active-low state.
2
Pin 19 — Thermal fan-speed control (TFSC) is a power-supply input signal used to control
the power-supply fan speed.
3
Pin 5 — PWRGOOD should measure between +4 and +5 VDC when the power supply is on
and operating to indicate that all power-supply output voltages are within ranges specified
in Table 1-4.
)LJXUH '& 3RZHU &RQQHFWRU 3
7DEOH 2SWL3OH[ ( '& 9ROWDJH 5DQJHV
9ROWDJH 5DQJH 0D[LPXP 2XWSXW &XUUHQW
+3.3 VDC +3.15 to +3.45 VDC 12.0 A 1
+5 VDC +4.75 to +5.25 VDC 18.0 A 1
+12 VDC +11.40 to +12.60 VDC
3.0 A 2
–12 VDC –10.80 to –13.20 VDC 0.3 A
–5 VDC –4.50 to –5.50 VDC 0.3 A
+5 VFP 3 +4.75 to +5.25 VDC 10 mA
1 The combined load on the +5-VDC and +3.3-VDC outputs should not exceed 105 W.
2 Withstands surges of up to 11.0 A to support disk start-up operations.
3
VFP (volts flea power) — sometimes called “standby power.”
11
1
PWRGOOD
3
(orange)
–12 VDC (blue)
+12 VDC (yellow)
+5 VFP (purple)
common (black)
2 3 4 5 6 7 8 9 10
12 13 14 15 16 17 18 19 20
P1
+5 VDC (red)
+5 VDC (red)
+5 VDC (red)
+5 VDC (red)
+5 VDC (red)
+5 VDC (red)
common (black)
common (black)
common (black)
PSON#
1
(gray)
common (black)
common (black)
common (black)
–5 VDC (white)
TFSC
2
(brown)