Dell Mobile Streak 7 Wifi Only - Manual (Page 56)

56 Internet
3 Flick the list and touch to select a Wi-Fi network you want to
connect to.
4 Enter a password (if necessary), then touch Connect to connect
to the Wi-Fi network.
NOTE: To connect to a network protected by Wired Equivalent Privacy
(WEP), Wi-Fi Protected Access (WPA), WPA2, or Wireless Protected Setup
(WPS), you must enter the WEP/WPA/WPA2/WPS security key to obtain
authorized access to the network. The next time your device connects to
a previously accessed secured wireless network, you will not be asked to
enter the WEP/WPA/WPA2/WPS key again, unless you reset your device
to its factory default settings.
NOTE: Your device has the ability to maintain a constant Internet
connection through Wi-Fi or data networks (GPRS, EDGE, 3G, 4G, or
HSPA). However, Wi-Fi connection has priority over mobile network
connection if both are available.
To check the current Wi-Fi network connection
From the status bar:
When your device is connected to a wireless network, the Wi-Fi icon
in the status bar indicates the signal strength (number of bands
that light up). If Wireless & networks
 Wi-Fi settings Network
notification is enabled, the icon appears in the status bar as the
device discovers an accessible Wi-Fi network within range.
From the Wi-Fi network:
1 Touch the Home button
 Menu button  Settings
Wireless & networks
 Wi-Fi settings.
2 Touch the Wi-Fi network that the device is currently connected to
(labeled Connected). A window opens displaying the Wi-Fi
network’s name, status, security info, signal strength, link speed,
and IP address.
NOTE: If you want to disconnect the Wi-Fi network from your device,
touch Forget on this window. You will need to configure the Wi-Fi
settings again if you want to restore connection to this wireless network.
LG7_bk0.book Page 56 Thursday, January 27, 2011 2:16 PM