Displays the, Diskette configuration submenu, Ide primary master submenu – Dell Dimension 2350 User Manual
Page 46

IDE Primary Master Submenu
Diskette Configuration Submenu
IDE Primary Slave
Identifies the second drive attached to the primary IDE interface, usually a second hard drive. The format of this submenu is the same
as the one described in "
."
IDE Secondary
Master
Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the one
described in "
."
IDE Secondary Slave Identifies the first drive attached to the secondary IDE interface, if there is one. The format of this submenu is the same as the one
described in "
."
Option
Function
IDE HDD Auto-Detection
Press
IDE Primary Master
Specifies the type of hard drive. Settings for this option are Auto (default), None, and Manual.
Capacity
Displays the maximum capacity of the primary IDE device.
Cylinder, Head, Precoup, Landing Zone,
Sector
Displays each setting of the primary IDE device.
Access Mode
Sets the access mode of the primary IDE device. The options are Auto (default), CHS, LBA, and Large.
PIO Mode
Sets the PIO mode of the primary IDE device. The options are Auto (default), Mode 0, Mode 1, Mode 2, Mode 3,
and Mode 4.
UDMA Mode
Sets the ultra DMA setting of the primary IDE device as either Auto (default) or Disabled.
Option
Function
Diskette Controller Configures the floppy drive interface. Options are Enabled (default) and Disabled.
Drive A:
Selects the floppy drive type as 1.44M, 3.5 in (default); None; 360K, 5.25 in; 1.2M, 5.25 in; 720K, 3.5 in; or 2.88M, 3.5 in.
Floppy 3 Mode
Support
Selects Floppy 3 mode support for the floppy drive. Options are Disabled (default) and Drive A.