Dell PowerVault 775N (Rackmount NAS Appliance) - Manual (Page 66)

Each HBA can be connected to a maximum of four storage systems
The integrated bridge on a tape library can be added to any zone.
NOTE: If you are sharing a storage system with multiple clusters or a combination of clustered and nonclustered
systems (hosts), you must install Access Logix and enable Access Control. Otherwise, you can only have one
nonclustered system or one NAS cluster attached to the Dell | EMC storage system.
SAN-Attached Cluster Configurations
Certain rules and requirements apply when you configure your SAN-attached cluster. See the Platform Guide for information
about supported servers, specific HBA models supported by the platform, and PCI slot configuration guidelines.
Table 5-5 provides a list of the documentation you will need to configure a SAN-attached cluster.
Table 5-5. SAN-Attached Cluster Configuration Documentation
Information Documentation Location
General rules and guidelines for SAN-attached cluster
configurations
Rules and requirements for cluster consolidation
configurations
This document
Platform Guide and
this document
Included with your NAS cluster or at the
Dell Support website at support.dell.com
Using Windows Storage Server 2003, Enterprise
Edition for NAS cluster products and components
This document
Installing the Navisphere software
EMC storage
system
documentation
Included with your storage system or at the
EMC Support website at www.emc.com
Latest firmware and software revision requirements EMC Support
Matrix
EMC Technical Library at www.emc.com
Platform Guide Included with your NAS cluster, or at the Dell
Support website at support.dell.com
Back to Contents Page