Dell Inspiron 1100 - Manual (Page 105)

Adding and Replacing Parts 105
NOTE: Dell does not
guarantee compatibility
or provide support for
hard drives from sources
other than Dell.
To replace the hard drive in the hard drive bay:
1 Complete the instructions in "Before You Add or Replace Parts" on
page 100.
2 Turn the computer over, and remove the hard drive screws.
NOTICE: When the hard drive is not in the computer, store it in protective
antistatic packaging. See "Protecting Against Electrostatic Discharge" on
page 17.
3 Slide the hard drive out of the computer.
4 Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use
excessive force, you may damage the connector.
5 Insert the drive into the bay, and push the hard drive until it is fully
seated in the bay.
6 Replace and tighten the screws.
screws (2)
hard drive