Dell Dimension 4500S - Manual (Page 22)

top into place. (Operating the computer without a hard-drive shroud does not affect its performance.)
16. Close the computer cover .
17. Attach the computer stand (optional).
18. Connect your computer and devices to electrical outlets, and turn them on.
19. See the documentation that came with the drive for instructions on installing any software required for drive operation.
Floppy Drive
1. Shut down the computer .
2. Turn off any attached devices and disconnect them from their electrical outlets.
3. Disconnect the computer power cable from the wall outlet, and then press the power button to ground the system board.
4. Remove the computer stand , if it is attached.
5. Open the computer cover .
6. Disconnect the power and data cables from the back of the drive that is installed in the CD/DVD drive bay above the floppy drive.
7. Disconnect the power and floppy-drive data cables from the back of the floppy drive.
8. Press inward on the two tabs on the sides of the drive, slide the drive upward, and remove it from the floppy-drive bay.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
CAUTION: Before you begin any of the procedures in this section, follow the " Safety Instructions ."
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTICE: To disconnect a network cable, first unplug the cable from your computer and then unplug it from the network wall jack.