Dell PowerVault 110T SDLT320 (Tape Drive) - Manual (Page 29)

Step 7: Secure the Drive
Secure the tape drive into place by pushing it gently into the bay until you feel it snap into place. At the same time, you will hear a faint clicking noise. These are your cues
that the drive is fully secured.
Replace the system's exterior cover.
External Drive: Rear Panel View
The rear panel of the external tape drive offers the features shown in Figure 8 .
Figure 8. External Drive: Rear Panel View
Installing External Drives
Installing the Tape Backup Software
Installation Prerequisites
NOTE: If the drive is the last device on the SCSI bus, it must be terminated, as shown in Figure 7 .
1
SCSI ID
Selector
2
SCSI
Connectors (2)
3 Fan
4
Power
Connector
5 Power Switch
NOTE: Check your system documentation to verify that you have a supported configuration of tape drive. Also, refer to your tape backup software documentation for
full details about how to install and operate your backup software application.