Dell PowerVault 110T SDLT320 (Tape Drive) - Manual (Page 24)

Table 4. ESD Failure Level Limits
Acoustic Noise Emissions
Table 5 provides the tape drive's acoustic noise emission levels, both as noise power and sound pressure.
Table 5. Acoustic Noise Emissions, Nominal
Back to Contents Page
* The tape drive shall maintain normal operation both in Read/Write and in Standby conditions. No errors attributable to the test shall be encountered.
‡ Conducted: The transient voltage is the actual peak voltage above the normal AC voltage from the power source. The maximum energy in a single pulse from the transient
generator must be limited to 2.5 W.
Failure Type Equipment Specifications Comments
Hard Office 1 to 12 kV No operator intervention (soft recoverable allowed)
Hardware Office Up to 15 kV No component damage; operator intervention allowed (soft/hard errors allowed)
Acoustics - Preliminary declared values per ISO 9296 and ISO 7779/EN27779
Mode Noise Power Emission Level (LNPEc) Internal Version External Version
Idle Not applicable 5.4 Bel
Streaming 5.9 Bel 5.9 Bel
Mode Sound Pressure Level (LPAc) Internal Version External Version
Idle Not applicable 42 dB
Streaming 47 dB 53 dB