Dell Dimension 9200c - Manual (Page 47)

Removing and Installing Parts: Dell Dimension 9200C Service Manual
file:///T|/htdocs/systems/dim9200C/en/SM_EN/parts.htm[10/31/2012 8:07:53 AM]
1 data cable 2 power cable 3 CD/DVD connector
4. Connect the data cable to the CD/DVD connector on the system board.
5. Gently position the drive until it clicks into place.
1 CD/DVD drive 2 CD/DVD drive bracket
6. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
7. Replace the computer cover (see Replacing the Computer Cover ).
8. Connect your computer and devices to electrical outlets, and then turn them on.
9. See the documentation that came with the drive for instructions on installing any software required for drive operation.
10. Enter System Setup (see Entering System Setup ), and then select the appropriate Drive option.
Floppy Drive (Optional)
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
Removing a Floppy Drive
1. Follow the procedures in Before You Begin .
2. Remove the CD/DVD drive, if installed (see Removing a CD/DVD Drive ).
3. Pull up on the drive release latch and slide the floppy drive towards the back of the computer.
4. Carefully, lift the drive away from the computer.