Dell PowerEdge 800 - Manual (Page 46)

6. Compress the two release tabs on the top of the fan assembly and lift the fan assembly away from the system. See Figure 6 -3 .
Figure 6-3. Removing and Replacing the Front System Fan
Installing the Front System Fan
1. Insert the fan power cable through the routing hole in the expansion-card guide bracket. See Figure 6 -2 .
2. Align the fan assembly with the slots in the chassis and lower the assembly into the chassis. See Figure 6 -3 .
3. Pull the fan cable through the routing hole in the expansion-card guide bracket. See Figure 6 -2 .
4. Connect the fan cable connector to the FRONT_FAN connector on the system board.
5. Install the cover. See " Replacing the Cover " in "Troubleshooting Your System."
6. Stand the system upright.
7. Install the bezel. See " Installing the Bezel " in "Troubleshooting Your System."
8. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Removing the Back System Fan
CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting
against electrostatic discharge.