Casio fx-50F PLUS - Manual (Page 65)

E-64
6. After inputting the program, press
A or !5(EXIT).
• To run the program you just created, press
w here to display the RUN Program
screen. For more information, see “Running a Program” below.
• To return to the normal calculation screen, press
,b to enter the COMP Mode.
A Editing an Existing Program
1. Press
,g(PRGM)b(EDIT) to display the EDIT Program screen.
2. Use number keys b through e to select the program area that contains the program
you want to edit.
3. Use e and d to move the cursor around the program, and perform the required
operations to edit the contents of the program or to add new contents.
• Pressing
f jumps to the beginning of the program, while c jumps to the end.
4. After you fi nish editing the program, press
A or !5(EXIT).
k Running a Program
You can run a program in the PRGM Mode or from another mode.
A Running a Program from Outside the PRGM Mode
1. Press 5.
2. Use number keys b through e to select a program area and execute its program.
A Running a Program in the PRGM Mode
1. Press
,g(PRGM) to display the PRGM Mode initial screen.
2. Press c(RUN).
• This will display the RUN Program screen.
Program areas that already contain program data (P1 through P4)
Remaining program memory capacity
3. Use number keys b through e to select the program area that contains the program
you want to run.
• This will execute the program in the program area you select.
A What to do if an error message appears
Press d or e. This will display the editing screen for the program, with the cursor located
at the location where the error was generated so you can correct the problem.
k Deleting a Program
You can delete an existing program by specifying its program area number.
A Deleting the Program in a Specifi c Program Area
1. Press
,g(PRGM) to display the PRGM Mode initial screen.
P1 P2 P3 P4
1 2 3 4
P1 P2 P3 P4
1 2 3 4
RUN P r o g r am
P-1234 670
RUN P r o g r am
P-1234 670