Casio fx-50F PLUS - Manual (Page 64)

E-63
k Creating a Program
A Creating a New Program
Example: To create a program that converts inches to centimeters (1 inch = 2.54 cm)
?
→ A : A × 2.54
1. Press
,g(PRGM) to enter the PRGM Mode.
2. Press b(EDIT).
Program areas that already contain program data (P1 through P4)
Remaining program memory capacity
3. Press the number key that corresponds to an unused program area number.
• This displays the run mode selection menu. Use e and d to switch between menu
screen 1 and screen 2.
MODE : BASE SD REG
3 4 5
MODE : COMP CMPLX
1 2
Screen 1 Screen 2
4. Press the number key that corresponds to the mode you want to assign as the program’s
run mode.
• Here, select b(COMP) on screen 1. This selects COMP
as the run mode, and displays the program editing
screen.
Important!
You cannot change the run mode of a program once it has been assigned. A run mode can
be assigned only when you are creating a new program.
5. Input the program.
• Here we will input the program shown below.
Program ?
→ A : A × 2.54
Key Operation
!d(P-CMD)b(?)
!~(STO)-(A)w
a-(A)*c.fe
•
!d(P-CMD) displays a special program command input screen. See “Inputting
Commands” on page 65 for more information.
ED I T RUN DEL
1 2 3
ED I T RUN DEL
1 2 3
E DI T P r o g r am
P-1234 670
E DI T P r o g r am
P-1234 670
I
000
I
000
?
→A:A×2. 54
010
?
→A:AЧ2. 54
010