Dell PowerVault MD1120 - Manual (Page 28)

28
Installing Enclosure Components
3 Push inward on the release tab on the bezel and lift it away from the
enclosure front (see Figure 3-1).
Figure 3-1. Installing and Removing the Front Bezel
4 To replace the bezel, insert the interlocking notch into the latch retainer
on the right side of the front enclosure panel.
5 Snap the left side of the bezel into place by inserting the interlocking
notch into the latch retainer on the left side of the front enclosure panel.
6 To lock the bezel, insert the key and turn it to the right.
Removing and Installing Physical Disks
Your enclosure supports up to 24 SAS physical disks, each one contained in its
individual physical disk carrier. Each physical disk is hot-pluggable, allowing
you to remove and insert physical disks without shutting down your
enclosure.
1 bezel lock 2 interlocking notch (2)
3 latch retainer (2)
2
1
3