Display, Removing the display assembly, Replacing the display latch – Dell LATITUDE D400 User Manual
Page 10
Back to Contents Page
Display
Removing the Display Assembly
1.
Follow the instructions in "
Preparing to Work Inside the Computer
" to remove the battery and prepare the computer for work.
2.
Remove the battery.
3.
Remove the
hard drive
.
4.
Remove the
center control cover
.
5.
Remove the two M2.5 x 6-mm screws next to each hinge.
6.
Remove the two M2.5 x 6-mm screws from the display-feed flex cable hold-down board.
7.
Use the pull-tab to disconnect the display-feed flex cable from its connector on the system board.
8.
Move the display assembly to an upright position and pull it up out of the computer.
Replacing the Display Latch
CAUTION:
Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
1 display-feed flex cable
2 M2.5 x 6-mm screws (6)
4911U
3 display-feed flex cable hold-down board
4 pull-tab
CAUTION:
Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.