Dell Inspiron One 2020 (Early 2012) - Manual (Page 37)

Antenna-In Connector | 37
13 Antenna-In Connector
WARNING: Before working inside your computer, read the safety information that
shipped with your computer and follow the steps in "Before You Begin" on page 11.
For additional safety best practices information, see the Regulatory Compliance
Homepage at dell.com/regulatory_compliance.
Removing the Antenna-In Connector
Prerequisites
1 Remove the stand cover. See "Removing the Stand Cover" on page 15.
2 Remove the stand. See "Removing the Stand" on page 17.
3 Remove the back cover. See "Removing the Back Cover" on page 19.
4 Remove the system-board shield. See "Removing the System-Board Shield" on
page 35.
Procedure
1 Remove the hex nut that secures the antenna-in connector to the
system-board shield.
2 Slide the antenna-in connector through the slot on the system-board shield.
3 Remove the antenna-in connector along with its cable away from the
system-board shield.
1 antenna-in connector 2 hex nut
2
1
book.book Page 37 Monday, April 16, 2012 3:04 PM