Palm rest, Removing the palm rest – Dell Latitude D520 User Manual
Page 33
Back to Contents Page
Palm Rest
Dell™ Latitude™ D520 Service Manual
Removing the Palm Rest
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the media bay device (see
Media Bay
).
3.
Remove the hard drive (see
Removing the Hard Drive
).
4.
Remove the hinge cover (see
Hinge Cover
).
5.
Remove the keyboard (see
Removing the Keyboard
).
6.
Remove the display assembly (see
Removing the Display Assembly
).
7.
Turn the computer upside down and remove the 14 M2.5 x 8-mm screws from the bottom of the computer.
8.
Turn the computer top-side up and remove the four M2.5 x 5-mm screws labeled "P" from the top of the palm rest.
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE:
To help prevent damage to the system board, remove the main battery (see
Before Working Inside Your Computer
) before working inside the
computer.
NOTE:
The screw locations may vary slightly from the image shown below.
1
M2.5 x 8-mm screws (14)