Display panel, Removing the display panel – Dell Latitude D520 User Manual
Page 16
3.
Replace the five rubber display bumpers around the display bezel.
Display Panel
Removing the Display Panel
1.
Follow the instructions in
Before Working Inside Your Computer
.
2.
Remove the display assembly (see
).
3.
).
4.
Remove the eight M2 x 5-mm screws in sequential order (four on each side of the display panel).
5.
Lift the display panel out of the display back cover.
6.
Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
CAUTION:
Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE:
To help prevent damage to the system board, you must remove the main battery (see
Before Working Inside Your Computer
) before you
begin working inside the computer.
1
display panel
2
M2 x 5-mm screws (8)
3
display back cover
1 pull-tab on bottom flex-cable
connector
2 top flex-cable
connector
3 display cable
connector