Scan mode – Dell KVM 4322DS User Manual
Page 60
50
xxx
|
Local and Remote Configuration
xxx
1
Enter the RCS host IP address that the Serial SIP is connected to.
2
Enter
3
Enter the password for the RCS user.
NOTE: The Telnet feature default is disabled. To enable Telnet support, refer
to "Configuring Serial Sessions" on page 77.
To switch to the active session from the local UI (local users only):
1
From the side navigation bar, select Local Session.
2
Select the Resume Active Session checkbox. The Video Viewer window will
appear.
Scan Mode
In Scan mode, the switch scans multiple target devices. The scanning order is
determined by placement of the target device in the list. You can also configure
the amount of time before the scan moves to the next target device in the
sequence.
NOTE: The Scan button is disabled if you are connected via modem.
To add target devices to the Scan list:
1
From the side navigation bar, select Unit View - Target List to open the
Target Devices screen.
2
Select the checkboxes next to the names of the target devices you wish to
scan.
3
Click Scan.
To configure Scan Time:
1
From the side navigation bar, select Ports - Local Port UI to open the
Local Port UI Settings screen.
2
Under the Scan Mode heading, enter an amount of time in seconds (from 3-
255) in the Scan Time field.