Dell Latitude C800 - Manual (Page 33)

Removing and Replacing Parts 31
2 Remove the four 4-mm screws located across the top of the bezel.
3 Use a scribe at the indentations to pry out the two plastic screw covers
located at the bottom of the bezel.
4 Remove the two 4-mm screws located at the bottom of the bezel.
5 Separate the bezel from the display-assembly top cover.
The bezel is secured to the display assembly top cover with plastic tabs
around the sides. Use a plastic scribe to help separate the bezel from
the top cover.
Removing the Display Panel
1 Remove the hinge cover .
2 Detach the display flex cable from the strain relief and the graphics
card.
3 Remove the display assembly bezel .
4 Remove the 4-mm screw securing the plastic flex cable mounting
bracket to the top cover assembly.
5 Remove the six 3-mm screws (three on each side) from the right and
left sides of the panel.
6 Lift the display panel and flex cable out of the top cover assembly.
7 Disconnect the flex cable from the two connectors (a ZIF and a
standard connector) on the display panel assembly.
64mcwc11.book Page 31 Tuesday, April 3, 2001 9:58 AM