Dell Dimension 9150/XPS 400 - Manual (Page 74)

74
Removing and Installing Parts
Installing Memory
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity
from your body before you touch any of your computer’s electronic components. You can do so by
touching an unpainted metal surface on the computer.
1 Follow the procedures in "Before You Begin" on page 63.
2 Remove the computer cover (see page 68).
3 Lay the computer on its side so that the system board is on the bottom of the inside of the
computer.
4 Press out the securing clip at each end of the memory module connector.
securing clips (2)
connector
memory connector closest
to processor