Dell Inspiron 17 (5748, Mid 2013) - Manual (Page 73)

Removing the Display
Assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer . After working inside your
computer, follow the instructions in After Working Inside Your
Computer . For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
NOTE: These instructions are applicable only for laptops with non-
touchscreen display.
1 Remove the battery .
2 Remove the base cover .
3 Follow the procedures from step 1 to step 3 in removing the hard drive .
4 Follow the procedures from step 1 to step 2 in removing the optical drive .
5 Remove the keyboard .
6 Remove the palm rest .
Procedure
1 Close the display and turn the computer over.
2 Disconnect the antenna cables from the wireless card.
3 Remove the antenna cables from the routing guides on the computer
base.
4 Slide the antenna cables through the slot on the computer base.
5 Turn the computer over and open the display as far as possible.
6 Peel off the tape that secures the display cable to the system board.
73