Dell 5530/dn Mono Laser Printer - Manual (Page 157)

35 Insufficient memory to support Resource Save feature
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to disable Resource Save and continue
printing.
• To enable Resource Save after receiving this message, make sure the link buffers are set to Auto, and then exit
the menus to activate the link buffer changes. When Ready appears, enable Resource Save.
• Install additional memory.
37 Insufficient memory for Flash Memory Defragment operation
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to stop the defragment process and
continue printing.
• Delete fonts, macros, and other data in printer memory.
• Install additional printer memory.
37 Insufficient memory to collate job
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to print the portion of the job already
stored and begin collating the rest of the print job.
• Cancel the current print job.
37 Insufficient memory, some held jobs were deleted
The printer deleted some held jobs in order to process current jobs.
Press the arrow buttons until Continue appears, and then press to clear the message.
37 Insufficient memory, some Held Jobs will not be restored
The printer was unable to restore some or all of the confidential or held jobs on the printer hard disk.
Press the arrow buttons until Continue appears, and then press to clear the message.
38 Memory full
Try one or more of the following:
• Press the arrow buttons until Continue appears, and then press to clear the message.
• Cancel the current print job.
• Install additional printer memory.
Understanding printer messages
157