Front stand, Removing the front stand – Dell Inspiron One 2205 (Mid 2010) User Manual
Page 23

Back to Contents Page
Front Stand
Dell™ Inspiron™ One 2205 Service Manual
Removing the Front Stand
1.
Follow the instructions in
Before You Begin
.
2.
Remove the back cover (see
Removing the Back Cover
).
3.
Remove the three screws that secure the front-stand assembly to the computer.
4.
Lift the rear stand so that the front stand is accessible.
5.
Carefully push and release the tab that secures the front-stand assembly to the middle frame.
6.
Release the tabs that secure the I/O bracket to the middle frame.
7.
Lift the front-stand assembly away from the computer.
8.
Remove the three screws that secure the I/O bracket to the front stand.
9.
Release the four tabs that secure the I/O bracket to the front stand.
10.
Remove the I/O bracket from the front stand.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1
screws (3)
2
rear stand
3
tab
4
front-stand assembly