Replacing the mini-card(s) – Dell Inspiron One 2205 (Mid 2010) User Manual
Page 14
Replacing the Mini-Card(s)
1.
Follow the instructions in
Before You Begin
.
2.
Align the notch on the Mini-Card with the tab in the system-board connector.
3.
Insert the Mini-Card at a 45-degree angle into the system-board connector.
4.
Press the other end of the Mini-Card down and replace the two screws that secure the Mini-Card to the system-board connector.
5.
Connect the appropriate antenna cable(s) to the Mini-Card you are installing. The following table provides the antenna cable color scheme for the Mini-
Card(s) supported by your computer.
6.
Replace the system-board shield (see
Replacing the System-Board Shield
).
7.
Replace the rear stand cover (see
Replacing the Rear Stand Cover
).
8.
Follow the instructions from
step 4
to
step 7
in
Replacing the Front Stand
.
9.
Replace the back cover (see
Replacing the Back Cover
).
10.
Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
1
Mini-Card
2
system board connector
3
screws (2)
CAUTION:
The connectors are keyed to ensure correct insertion. Use of excessive force may damage the connectors.
CAUTION:
To avoid damage to the Mini-Card, ensure that there are no cables or antenna cables under the Mini-Card.
Connectors on the Mini-Card Antenna Cable Color Scheme
WLAN (2 antenna cables)
Main WLAN (white triangle)
Auxiliary WLAN (black triangle)
white
black
TV tuner (1 antenna cable)
black
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.